EnermixPlus

Enermix Plus is a 100% acrylic-based product which, when mixed with Portland cement, provides a high build, exceptionally easy to trowel adhesive/embedding coat.

UsesEnermix Plus is utilized where a high build (maximum 1/4”), crack, resistant, cementitious coating is required, for example, to skim rough masonry, to fill small voids in cementitious substrates and as the base coat for mechanically fastened systems.
Surface PreparationSurfaces shall be above 40° F, unpainted and must be clean, dry, structurally sound, and free of efflorescence, grease, oil, form release agents and curing compounds.
MixingThoroughly premix the Enermix Plus. Into a clean plastic container, pour 1/2 of the freshly mixed Enermix Plus, add 1 quart of clean potable water and 1/3 of a bag (approximately 30 Ibs.) of fresh, lump-free cement slowly and mix thoroughly. Additional water may be added to the Enermix Plus mixture to achieve a workable consistency. Up to 1/2 gallon of water per 1/2 pail of Enermix Plus may be added. DO NOT OVERWATER THE Enermix Plus MIXTURE AS THIS WILL DEGRADE THE PERFORMANCE OF THE PRODUCT. Allow the mixture to set for five (5) minutes. Re-mix and temper by adding a small amount of water to achieve the desired workability
Job ConditionsTemperature for application of Enermix Plus must be 40° F or higher and must remain for a minimum of 24 hours.
StorageEnermix Plus must be stored at 40° F or above in tightly sealed containers out of direct sunlight.
ApplicationWith a stainless steel trowel, apply the Enermix Plus to the recommended substrate at a thickness not to exceed 1/4”. Enermix Plus may also be applied using spray equipment.
Drying TimeThe drying time of Enermix Plus mixture is dependent upon the air temperature and relative humidity. Under average drying conditions (70° F, 55% R.H.), protect work from rain for at least 24 hours. Being a cementitious product, Enermix Plus mixture develops full strength in 28 days.
Working TimeAfter mixing, the working time of Enermix Plus mixture is 2 to 4 hours, depending on ambient conditions.
Water Vapor Transmission(ASTM E-96): 10 perms.
Clean UpClean tools with water before Enermix Plus has set.

ProductMethodResults
Accelerated WeatheringASTM G-23 Passes 2000 hours.
Mildew ResistanceMil Std 810BNo growth of mildew.
Compressive StrengthASTM C-109 5460 psi (28 days).
Tensile StrengthASTM C-190 690 psi (28 days).
Freeze/ThawASTM C-666Passes 300 cycles.